< Back

A technical question? A technician will send you the answer under 24 hours All fields are required!


The HV electronic loads are used to test the EPC (Power supplies embedded in satellite).

Each drawer represents a HV electronic load which can withstand a high voltage (up to 30kV). The operator can define the current’s setting that the dynamic load could sink. Each electronic load works as a variable resistor : the value of this resistor is adjusted according to the current’s setting.

A different waveform can be be applied as the current setting (square, sinus,…).

Square signal_electronic_load

The device can be operated locally using front panel controls or remotly through a 25-pin remote control interface.